Recorder Accessories/Consumables
Recorder add-ons to extend the standard functions of your recorder with current, high voltage or temperature inputs. These accessories will not fit on the 100 mm recorders.
Note: the recorder accessories are ONLY available in the UK
Attenuator 10 x
The 10x attenuator divides the input voltages by a factor of 10. Maximum input voltage is 500 VDC. Input impedance is 1 MOhm.
Attenuator 100 x
The 100x attenuator divides the input voltages by a factor of 100 Maximum input voltage is 500 VDC. Input impedance is 1 MOhm.
Pen Offset Compensation
The POC module is meant as Pen Offset Compensation for the BD 12E. The module compensates the 2.5 mm distance between the pens by means of a buffer that holds the data during the 2.5 mm paper transport.
Shunt 0-16 MA
The POC module is meant as Pen Offset High current shunt for recorder ranges of 100 mV or 200 mV. Maximum continuous current is 16 A. Peak current is 20 A for 2 min. The shunt has no thermal or current protection and is tested for frequencies below 20 kHz.
Shunt 0-20 MA
This module transforms a 4-20 mA signal into a Voltage output by means of a highly accurate resistor (125 Ohm). Full accuracy is guaranteed over the recorder temperature range.
Shunt 4-20 MA
This module transforms a 4-20 mA signal into a Voltage output by means of a highly accurate resistor (125 Ohm). Full accuracy is guaranteed over the recorder temperature range.
Temperature Module J
The Temperature module J linearizes temperatures into voltages. The linearisation is 1 mV per 1°C per and 0°C is 0 mV.
Temperature Module K
The Temperature module K linearizes temperatures into voltages. The linearisation is 1 mV per 1°C per and 0°C is 0 mV.
Featured Products
Designed and created by Mark Redgrave
©Equinox Instruments Ltd 2010